DTC Troubleshooting: P1717 (62)
DTC P1717:
 Open in Transmission Range Switch ATP RVS Switch Circuit
NOTE:
  • Before you troubleshoot, record all freeze data and any on-board snapshot with the HDS, and review General Troubleshooting Information.
  • This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
K24Z3 Engine Model
  1. Turn the ignition switch to ON (II).
  1. Shift to R, and check the A/T R Switch in the Data List with the HDS.
Is the A/T R Switch ON?
YES -
Go to Step 3 .
NO -
Check for proper transmission range switch installation, adjust the shift cable, then recheck.■
  1. Check the Reverse Switch (ATP RVS) in the Data List with the HDS.
Is the Reverse Switch (ATP RVS) ON?
YES -
Intermittent failure, the system is OK at this time.■
NO -
Go to Step 4 .
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the transmission range switch connector.
  1. Check for continuity between transmission range switch connector terminal No. 5 and body ground.
Is there continuity?
YES -
Go to Step 7 .
NO -
Repair open in the wire between transmission range switch connector terminal No. 5 and body ground (G101), or repair poor ground (G101), then go to Step 10 .
  1. Turn the ignition switch to ON (II).