DTC Troubleshooting: P0962 (16)
  1. Check for continuity between A/T clutch pressure control solenoid valve A connector terminal No. 1 and PCM connector terminal B48.
Is there continuity?
YES -
Go to Step 24 .
NO -
Repair open in the wire between A/T clutch pressure control solenoid valve A connector terminal No. 1 and PCM connector terminal B48, then go to Step 18 .
  1. Reconnect all connectors.
  1. Turn the ignition switch to ON (II).
  1. Clear the DTC with the HDS.
  1. Start the engine, and wait for at least 1 second.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0962 indicated?
YES -
Check for poor connections or loose terminals between A/T clutch pressure control solenoid valve A and the PCM, then go to Step 1 .
NO -
Go to Step 23 .
  1. Monitor the OBD STATUS for P0962 in the DTCs MENU with the HDS.
Does the HDS indicate PASSED?
YES -
Troubleshooting is complete. If any other Temporary DTCs or DTCs were indicated in Step 22 , go to the indicated DTC's troubleshooting.■
NO -
If the HDS indicates FAILED, check for poor connections or loose terminals between A/T clutch pressure control solenoid valve A and the PCM, then go to Step 1 . If the HDS indicates NOT COMPLETED, go to Step 21 .
  1. Reconnect all connectors.
  1. Update the PCM if it does not have the latest software, or substitute a known-good PCM.
  1. Start the engine, and wait for at least 1 second.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0962 indicated?
YES -
Check for poor connections or loose terminals between A/T clutch pressure control solenoid valve A and the PCM. If the PCM was updated, substitute a known-good PCM, then go to Step 26 . If the PCM was substituted, go to Step 1 .
NO -
Go to Step 28 .
  1. Monitor the OBD STATUS for P0962 in the DTCs MENU with the HDS.
Does the HDS indicate PASSED?
YES -
If the PCM was updated, troubleshooting is complete. If the PCM was substituted, replace the original PCM. If any other Temporary DTCs or DTCs were indicated in Step 27 , go to the indicated DTC's troubleshooting.■
NO -
If the HDS indicates FAILED, check for poor connections or loose terminals between A/T clutch pressure control solenoid valve A and the PCM. If the PCM was updated, substitute a known-good PCM, then go to Step 26 . If the PCM was substituted, go to Step 1 . If the HDS indicates NOT COMPLETED, go to Step 26 .