DTC Troubleshooting: P0713 (28)
  1. Check for continuity between PCM connector terminal B28 and shift solenoid wire harness connector terminal No. 6.
Is there continuity?
YES -
Go to Step 27 .
NO -
Repair open in the wire between PCM connector terminal B28 and the ATF temperature sensor, then go to Step 21 .
  1. Reconnect all connectors.
  1. Turn the ignition switch to ON (II).
  1. Clear the DTC with the HDS.
  1. Start the engine with the shift lever in P, and wait for at least 20 seconds.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0713 indicated?
YES -
Check for poor connections or loose terminals between the ATF temperature sensor and the PCM, then go to Step 1 .
NO -
Go to Step 26 .
  1. Monitor the OBD STATUS for P0713 in the DTCs MENU with the HDS.
Does the HDS indicate PASSED?
YES -
Troubleshooting is complete. If any other Temporary DTCs or DTCs were indicated in Step 25 , go to the indicated DTC's troubleshooting.■
NO -
If the HDS indicates FAILED, check for poor connections or loose terminals between the ATF temperature sensor and the PCM, then go to Step 1 . If the HDS indicates NOT COMPLETED, go to Step 24 .
  1. Reconnect all connectors.
  1. Update the PCM if it does not have the latest software, or substitute a known-good PCM.
  1. Start the engine with the shift lever in P, and wait for at least 20 seconds.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0713 indicated?
YES -
Check for poor connections or loose terminals between the ATF temperature sensor and the PCM. If the PCM was updated, substitute a known-good PCM, then go to Step 29 . If the PCM was substituted, go to Step 1 .
NO -
Go to Step 31 .
  1. Monitor the OBD STATUS for P0713 in the DTCs MENU with the HDS.
Does the HDS indicate PASSED?
YES -
If the PCM was updated, troubleshooting is complete. If the PCM was substituted, replace the original PCM. If any other Temporary DTCs or DTCs were indicated in Step 30 , go to the indicated DTC's troubleshooting.■
NO -
If the HDS indicates FAILED, check for poor connections or loose terminals between the ATF temperature sensor and the PCM. If the PCM was updated, substitute a known-good PCM, then go to Step 29 . If the PCM was substituted, go to Step 1 . If the HDS indicates NOT COMPLETED, go to Step 29 .