DTC Troubleshooting: P0713 (28)
DTC P0713:
 Open in ATF Temperature Sensor Circuit
NOTE:
  • Before you troubleshoot, record all freeze data and any on-board snapshot with the HDS, and review General Troubleshooting Information.
  • This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
K24Z3 Engine Model
  1. Turn the ignition switch to ON (II).
  1. Check the ATF Temp Sensor voltage in the Data List with the HDS.
Does the ATF Temp Sensor voltage exceed 4.93 V?
YES -
Go to Step 3 .
NO -
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals between the ATF temperature sensor and the PCM.■
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the shift solenoid wire harness connector.
  1. Connect shift solenoid wire harness connector terminals No. 6 and No. 7 with a jumper wire.
  1. Turn the ignition switch to ON (II).
  1. Check the ATF Temp Sensor voltage in the Data List with the HDS.
Does the ATF Temp Sensor voltage exceed 4.93 V?
YES -
Go to Step 8 .
NO -
Replace the ATF temperature sensor, then go to Step 21 .
  1. Turn the ignition switch to LOCK (0).
  1. Remove the jumper wire from the shift solenoid wire harness connector.
  1. Turn the ignition switch to ON (II).