A/T Assembly Installation
  1. Connect the engine wire harness connectors:
    • A/T clutch pressure control solenoid valve B connector (A)
    • 2nd clutch transmission fluid pressure switch connector (B)
  1. Install the harness clamps (C) on the clamp brackets (D).
  1. Install the battery base.
  1. Install the air cleaner housing and the intake air duct.
  1. Install the PCM connectors, then install the PCM bracket.
  1. Do the battery installation procedure.
    NOTE: Do not the test-driving until Step 84 .
  1. Refill the transmission with ATF.
    NOTE: Do not the service reminder system reset until Step 84 .