A/T Assembly Installation
Special Tools Required

Engine support hanger
 AAR-T1256-J00

*
Subhanger stay
 07MAK-PY30100

Subframe alignment pin
 070AG-SJAA10S
*: This special tool is available from Snap-on Tools    International, LLC.
NOTE: Use fender covers to avoid damaging painted surfaces.
K24Z3 Engine Model
  1. Install a new O-ring (A) the torque converter (B), then install the torque converter on the mainshaft (C).
  1. Install the 14 x 20 mm dowel pins (D) in the torque converter housing.
  1. Place the transmission on a jack, and raise the transmission to the engine level, then fit the transmission to the engine.