ATF Cooler Hose Replacement
K24Z3 Engine Model
  1. Slide the ATF cooler/filter hoses (A) on the ATF filter (B) until they touch the filter housing, and secure the hoses with the clips (C) at 6−8 mm (0.24−0.31 in.) (D) from the filter housing.
  1. Slide the ATF cooler/filter hoses (E) over the ATF lines (F) until the hose ends contact the bulge (G), and secure the hoses with the clips (H) at 6−8 mm (0.24−0.31 in.) (I) from the hose end.
  1. Slide the ATF cooler inlet hose (J) over the ATF cooler inlet lines (K) until the hose ends contact the bulge (L), and secure the hose with the clips (M) at 6−8 mm (0.24−0.31 in.) (N) from the hose end.
  1. Slide the ATF cooler outlet hose (O) with pink dot end (P) over the ATF cooler outlet line (Q) until the hose end contact bulge (R), and secure the hose with the clip (S) at 6−8 mm (0.24−0.31 in.) (T) from the hose end.