DTC Troubleshooting: P0122 (7)
  1. Check for continuity between ECM/PCM connector terminal C12 and throttle body 6P connector terminal No. 2.
Is there continuity?
YES -
Go to Step 23 .
NO -
Repair open in the wire between the throttle body and the ECM/PCM (C12), then go to Step 18 .
  1. Turn the ignition switch to LOCK (0).
  1. Replace the throttle body.
  1. Reconnect all connectors.
  1. Turn the ignition switch to ON (II).
  1. Reset the ECM/PCM with the HDS.
  1. Do the ECM/PCM idle learn procedure.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0122 indicated?
YES -
Check for poor connections or loose terminals at the throttle body and the ECM/PCM, then go to Step 1 .
NO -
Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■
  1. Reconnect all connectors.
  1. Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0122 indicated?
YES -
Check for poor connections or loose terminals at TP sensor A and the ECM/PCM. If the ECM/PCM was updated, substitute a known-good ECM/PCM, then recheck. If the ECM/PCM was substituted, go to Step 1 .
NO -
If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■