DTC Troubleshooting: P0010 (56)
DTC P0010:
 VTC Oil Control Solenoid Valve Malfunction
NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.
  1. Turn the ignition switch to ON (II).
  1. Clear the DTC with the HDS.
  1. Start the engine. Hold the engine speed at 3,000 rpm (min −1 ) without load (A/T in P or N, M/T in neutral) until the radiator fan comes on, then let it idle.
  1. Do the VTC TEST in the INSPECTION MENU with the HDS.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0010 indicated?
YES -
Go to Step 6 .
NO -
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM/PCM.■
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the VTC oil control solenoid valve 2P connector.
  1. At the solenoid valve side, measure the resistance between VTC oil control solenoid valve 2P connector terminals No. 1 and No. 2.
Is there 6.75−8.25 Ω at room temperature?
YES -
Go to Step 9 .
NO -
Go to Step 14 .