Remove the mounting bolts and the A/C compressor (A). Be careful not to damage the radiator fins when removing the compressor.
Install the A/C compressor in the reverse order of removal, and note these items:
Inspect the A/C lines for any signs of contamination.
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the correct O-rings for HFC-134a (R-134a) to avoid leakage.
Use refrigerant oil (SP-10) for HFC-134a SANDEN spiral type A/C compressor only.
To avoid contamination, do not return the oil to the container once dispensed, and never mix it with other refrigerant oils.
Immediately after using the oil, reinstall the cap on the container, and seal it to avoid moisture absorption.
Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.
Be careful not to damage the radiator fins when installing the compressor and the A/C condenser fan shroud.