Throttle Body Removal/Installation
  1. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
  1. Turn the ignition switch to ON (II).
  1. Reset the ECM/PCM with the HDS.
  1. Select the ETCS TEST in the INSPECTION MENU with the HDS.
  1. Select TP POSITION CHECK and clear the throttle position (TP) learned value.
  1. Turn the ignition switch to LOCK (0).
  1. Turn the ignition switch to ON (II), and wait 2 seconds without pressing the accelerator pedal.
  1. Do the ECM/PCM idle learn procedure.