Injector Replacement
  1. Relieve the fuel pressure.
  1. Remove the engine cover.
  1. Remove the quick-connect fitting cover (A), then disconnect the quick-connect fitting (B).
  1. Disconnect the injector connectors (C) and the engine mount control solenoid valve connector (D).
  1. Remove the ground cable bolts (G101 and G102) (E).
  1. Remove the fuel rail mounting nuts (F) from the fuel rail (G).
  1. Remove the fuel rail and the injectors from the injector base.
  1. Remove the injector clips (H) from the fuel rail.
  1. Remove the injectors from the fuel rail.