F-CAN Circuit Troubleshooting
NOTE: Information marked with an asterisk ( * ) applies to the CANL line.
  1. Turn the ignition switch to LOCK (0).
  1. Jump the SCS line with the HDS.
  1. Disconnect ECM/PCM connector A (49P), then disconnect the HDS.
  1. Measure the resistance between ECM/PCM connector terminals A3 and A4.
Is there about 79−111 Ω?
YES -
Go to Step 44 .
NO -
Go to Step 5 .
  1. Disconnect these connectors:
    • Gauge control module 32P.
    • VSA modulator-control unit 47P.
    • Yaw rate-lateral acceleration sensor 4P.
    • EPS control unit D (28P).
    • SRS unit A (39P).
    • LKAS control unit 26P (with driving support system).
    • ACC unit 20P (with driving support system).
    • E-pritensioner unit 14P (with driving support system).
    • Navigation unit 32P (with navigation system).