DLC Circuit Troubleshooting
  1. Check for continuity between ECM/PCM connector terminal C13 and body ground.
Is there continuity?
YES -
Go to Step 75 .
NO -
  • A/T: Go to Step 76 .
  • M/T: Go to Step 78 .
  1. Continue to check for continuity between ECM/PCM connector terminal C13 and body ground, while disconnecting these connectors, one at a time:
    • MAP sensor 3P connector
    • Output shaft (countershaft) speed sensor 3P connector.
Does continuity go away when one of the above connectors is disconnected?
YES -
Replace the part that caused an open when it was disconnected.■
NO -
Repair short in the wires between the ECM/PCM (C13) and the MAP sensor or the output shaft (countershaft) speed sensor.■