Cylinder Head Valve, Spring, and Valve Seal Installation
Special Tools Required

Stem seal driver
 07PAD-0010000

Valve spring compressor attachment
 07757-PJ10100

Valve spring compressor
 07757-0010000
  1. Coat the valve stems with new engine oil. Install the valves in the valve guides.
  1. Check that the valves move up and down smoothly.
  1. Install the spring seats on the cylinder head.
  1. Install the new valve seals (A) using the stem seal driver (B).
    NOTE: The exhaust valve seal (C) has a black spring (D), and the intake valve seal (E) has a white spring (F). They are not interchangeable.
  1. Install the valve spring and the spring retainer. Place the end of the valve spring with the closely wound coils toward the cylinder head.