Cam Chain Inspection
Special Tools Required

Pin driver, 5.0 mm
 07GAD-PG20100
  1. Remove the front wheels.
  1. Remove the splash shield.
  1. Remove the four spark plugs.
  1. Remove the cylinder head cover.
  1. Rotate the crankshaft pulley two turns clockwise.
  1. Set the No. 1 piston at top dead center (TDC). The punch mark (A) on the variable valve timing control (VTC) actuator and the punch mark (B) on the exhaust camshaft sprocket should be at the top. Align the TDC marks (C) on the VTC actuator and the exhaust camshaft sprocket.