Camshaft Inspection
  1. Remove the camshaft holders. Measure the widest portion of plastigage on each journal.
    • If the camshaft-to-holder clearance is within limits, go to Step 11 .
    • If the camshaft-to-holder clearance is beyond the service limit, and the camshaft has been replaced, replace the cylinder head.
    • If the camshaft-to-holder clearance is beyond the service limit, and the camshaft has not been replaced, go to Step 10 .
    Camshaft-to-Holder Oil Clearance
    Standard (New):
    No. 1 Journal:
    0.030−0.069 mm
    (0.001−0.003 in.)
    No. 2, 3, 4, 5 Journals:
    0.060−0.099 mm
    (0.002−0.004 in.)
    Service Limit:
    0.15 mm (0.006 in.)