|
NOTE: Do not rotate the camshaft during inspection.
-
-
Put the rocker shaft holders, the camshaft, and the camshaft holders on the cylinder head, then tighten the bolts, in sequence, to the specified torque.
NOTE: If the engine does not have bolt (21), skip it and continue the torque sequence.
|
Specified Torque
|
|
8 x 1.25 mm 22 N·m (2.2 kgf·m, 16 lbf·ft)
|
|
6 x 1.0 mm 12 N·m (1.2 kgf·m, 8.8 lbf·ft)
|
|
6 x 1.0 mm Bolts: (21), (22), (23)
|
-
Seat the camshaft by pushing it away from the camshaft pulley end of the cylinder head.
|