Cylinder Head Installation
  1. Install the evaporative emission (EVAP) canister hose (A).
  1. Install the catalytic converter.
  1. Install the intake manifold.
  1. Install the drive belt.
  1. Install the strut brace.
  1. After installation, check that all tubes, hoses, and connectors are installed correctly.
  1. Inspect for fuel leaks. Turn the ignition switch to ON (II) (do not operate the starter) so the fuel pump runs for about 2 seconds and pressurizes the fuel line. Repeat this operation three times, then check for fuel leakage at any point in the fuel line.
  1. Refill the radiator with engine coolant, and bleed air from the cooling system with the heater valve open.
  1. Inspect the idle speed.
  1. Inspect the ignition timing.