DTC Troubleshooting: P1717 (62)
DTC P1717:
 Open in Transmission Range Switch ATP RVS Switch Circuit
NOTE:
  • Before you troubleshoot, record all freeze data and any on-board snapshot with the HDS, and review General Troubleshooting Information.
  • This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
R20A3 Engine Model
  1. Turn the ignition switch to ON (II).
  1. Shift to R, and check the A/T R Switch in the Data List with the HDS.
Is the A/T R Switch ON?
YES -
Go to Step 3 .
NO -
Check for proper transmission range switch installation, adjust the shift cable, then recheck.■
  1. Check the Reverse Switch (ATP RVS) in the Data List with the HDS.
Is the Reverse Switch (ATP RVS) ON?
YES -
Intermittent failure, the system is OK at this time.■
NO -
Go to Step 4 .
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the transmission range switch connector.
  1. Check for continuity between transmission range switch connector terminal No. 10 and body ground.
Is there continuity?
YES -
Go to Step 7 .
NO -
Repair open in the wire between transmission range switch connector terminal No. 10 and body ground (G101), or repair poor ground (G101), then go to Step 10 .
  1. Turn the ignition switch to ON (II).