DTC Troubleshooting: P0843 (25)
  1. Check for continuity between PCM connector terminal B8 and the 2nd clutch transmission fluid pressure switch connector terminal.
Is there continuity?
YES -
Go to Step 23 .
NO -
Repair open in the wire between PCM connector terminal B8 and the 2nd clutch transmission fluid pressure switch, then go to Step 16 .
  1. Reconnect all connectors.
  1. Turn the ignition switch to ON (II).
  1. Clear the DTC with the HDS.
  1. Start the engine, and warm it up to normal operating temperature (the radiator fan comes on).
  1. Test-drive the vehicle in 2nd gear with the shift lever in D for at least 2 seconds. Then drive in 4th gear for at least 2 seconds.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0843 indicated?
YES -
Check for poor connections or loose terminals between the 2nd clutch transmission fluid pressure switch and the PCM, then go to Step 1 .
NO -
Go to Step 22 .
  1. Monitor the OBD STATUS for P0843 in the DTCs MENU with the HDS.
Does the HDS indicate PASSED?
YES -
Troubleshooting is complete. If any other Temporary DTCs or DTCs were indicated in Step 21 , go to the indicated DTC's troubleshooting.■
NO -
If the HDS indicates FAILED, check for poor connections or loose terminals between the 2nd clutch transmission fluid pressure switch and the PCM, then go to Step 1 . If the HDS indicates NOT COMPLETED, go to Step 19 .
  1. Reconnect all connectors.
  1. Update the PCM if it does not have the latest software, or substitute a known-good PCM.
  1. Start the engine, and warm it up to normal operating temperature (the radiator fan comes on).
  1. Test-drive the vehicle in 2nd gear with the shift lever in D for at least 2 seconds. Then drive in 4th gear for at least 2 seconds.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0843 indicated?
YES -
Check for poor connections or loose terminals between the 2nd clutch transmission fluid pressure switch and the PCM. If the PCM was updated, substitute a known-good PCM, then go to Step 25 . If the PCM was substituted, go to Step 1 .
NO -
Go to Step 28 .
  1. Monitor the OBD STATUS for P0843 in the DTCs MENU with the HDS.
Does the HDS indicate PASSED?
YES -
If the PCM was updated, troubleshooting is complete. If the PCM was substituted, replace the original PCM. If any other Temporary DTCs or DTCs were indicated in Step 27 , go to the indicated DTC's troubleshooting.■
NO -
If the HDS indicates FAILED, check for poor connections or loose terminals between the 2nd clutch transmission fluid pressure switch and the PCM. If the PCM was updated, substitute a known-good PCM, then go to Step 25 . If the PCM was substituted, go to Step 1 . If the HDS indicates NOT COMPLETED, go to Step 25 .