A/T Assembly Installation
  1. Connect the A/T clutch pressure control solenoid valve A connector (A).
  1. Install the harness clamps (B) on the clamp brackets (C).
  1. Install the battery base.
  1. Install the air cleaner housing and the intake air duct.
  1. Install the PCM connectors, then install the PCM bracket.
  1. Do the battery installation procedure.
    NOTE: Do not the test-driving until Step 88 .
  1. Refill the transmission with the ATF.
    NOTE: Do not the service reminder system reset until Step 88 .