A/T Assembly Removal
Special Tools Required

Engine support hanger
 AAR-T1256-J00

*
Subhanger stay
 07MAK-PY30100
*: This special tool is available from Snap-on Tools    International, LLC.
NOTE:
  • Use fender covers to avoid damaging painted surfaces.
  • To avoid damaging the wires and the terminals, unplug the wiring connectors carefully while holding the connector portion.
  • Mark all wiring and hoses to avoid misconnection. Also, be sure that they do not contact other wiring or hoses, or interfere with other parts.
  • Engine support hanger (AAR-T1256-J00) must be used with the side engine mount installed.
R20A3 Engine Model
  1. Secure the hood in the wide open position with the support strut.
  1. Do the battery removal procedure.
  1. Remove the harness clamps from the PCM bracket, then remove the two bolts securing the PCM bracket. Disconnect the PCM connectors from the PCM.
  1. Remove the front grille cover.
  1. Remove the brake booster vacuum hose clamp (A) and the nuts (B), then remove the strut brace (C).
  1. Remove the air cleaner housing and the intake air duct.
  1. Remove the battery base.
  1. Raise the vehicle on a lift, and make sure it is securely supported.
  1. Remove the front wheels.
  1. Remove the splash shield.