DTC Troubleshooting: P2649 (21)
  1. Check for continuity between ECM/PCM connector terminal B34 and rocker arm oil control solenoid 2P connector terminal No. 1.
Is there continuity?
YES -
Go to Step 19 .
NO -
Repair open in the wire between the ECM/PCM (B34) and the rocker arm oil control solenoid, then go to Step 13 .
  1. Replace the rocker arm oil control valve.
  1. Reconnect all connectors.
  1. Turn the ignition switch to ON (II).
  1. Reset the ECM/PCM with the HDS.
  1. Do the ECM/PCM idle learn procedure.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P2649 indicated?
YES -
Check for poor connections or loose terminals at the rocker arm oil control solenoid and the ECM/PCM, then go to Step 1 .
NO -
Go to Step 18 .
  1. Monitor the OBD STATUS for DTC P2649 in the DTCs MENU with the HDS.
Does the screen indicate PASSED?
YES -
Troubleshooting is complete. If any other Temporary DTCs or DTCs were indicated in Step 17 , go to the indicated DTC's troubleshooting.■
NO -
If the screen indicates FAILED, check for poor connections or loose terminals at the rocker arm oil control solenoid and the ECM/PCM, then go to Step 1 . If the screen indicates NOT COMPLETED, go to Step 16 .
  1. Reconnect all connectors.
  1. Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM.
  1. Start the engine.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P2649 indicated?
YES -
Check for poor connections or loose terminals at the rocker arm oil control solenoid and the ECM/PCM. If the ECM/PCM was updated, substitute a known-good ECM/PCM, then go to Step 21 . If the ECM/PCM was substituted, go to Step 1 .
NO -
Go to Step 23 .
  1. Monitor the OBD STATUS for DTC P2649 in the DTCs MENU with the HDS.
Does the screen indicate PASSED?
YES -
If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM. ■
NO -
If the screen indicates FAILED, check for poor connections or loose terminals at the rocker arm oil control solenoid and the ECM/PCM. If the ECM/PCM was updated, substitute a known-good ECM/PCM, then go to Step 21 . If the ECM/PCM was substituted, go to Step 1 . If the screen indicates NOT COMPLETED, keep idling until a result comes on.