DTC Troubleshooting: P0351 (71), P0352 (72), P0353 (73), P0354 (74)
  1. Check for continuity between appropriate ignition coil 3P connector terminal No. 1 and the appropriate ECM/PCM connector terminal of the problem cylinder (see table).
    PROBLEM CYLINDER
    DTC
    ECM/PCM TERMINAL
    WIRE COLOR
    No. 1
    P0351
    C15
    YEL/GRN
    No. 2
    P0352
    C16
    BLU/RED
    No. 3
    P0353
    C25
    WHT/BLU
    No. 4
    P0354
    C19
    BRN

Is there continuity?
YES -
Go to Step 31 .
NO -
Repair open in the wire between the ECM/PCM and the ignition coil, then go to Step 25 .
  1. Turn the ignition switch to LOCK (0).
  1. Reconnect all connectors.
  1. Turn the ignition switch to ON (II).
  1. Reset the ECM/PCM with the HDS.
  1. Do the ECM/PCM idle learn procedure.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0351, P0352, P0353, and/or P0354 indicated?
YES -
Check for poor connections or loose terminals at the ignition coil and the ECM/PCM, then go to Step 1 . If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.
NO -
Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■
  1. Reconnect all connectors.
  1. Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0351, P0352, P0353, and/or P0354 indicated?
YES -
Check for poor connections or loose terminals at the ignition coil and the ECM/PCM. If the ECM/PCM was updated, substitute a known-good ECM/PCM, then recheck. If the ECM/PCM was substituted, go to Step 1 .
NO -
If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■