Identify each part as it is removed so that each item can be reinstalled in its original position.

Inspect the rocker arm shaft and the rocker arms.

If reused, the rocker arms must be installed in their original location.

When removing, or installing the rocker arm assembly, do not remove the lost motion holder bolts. The bolts will keep the holders and the rocker arms on the shaft.

Remove the rocker shaft bolt before removing the rocker shaft from the No. 5 rocker shaft holder.

Prior to reassembling, clean all the parts in solvent, dry them, and apply new engine oil to any contact points.

Bundle the intake secondary rocker arms with rubber bands to keep them together as a set.

When replacing the intake rocker arm assembly, remove the fastening hardware from the new intake rocker arm assembly.