A/T 1st, 2nd, and 3rd Clutch Reassembly
Special Tools Required

Clutch spring compressor set
 07LAE-PX40000

Clutch spring compressor attachment
 07LAE-PX40100

Clutch spring compressor attachment
 07HAE-PL50100

Clutch spring compressor bolt set 10
 07GAE-PG40200

Snap ring pliers
 07LGC-0010100
NOTE:
  • Hold the spring compressor attachment in a vise with soft jaws. Be careful not to damage the clutch drum.
  • Insert the spring retainer can be adjusted (center of tolerance) to prevent damaging the spring retainer oil seal.
  1. Soak the clutch discs thoroughly in ATF for at least 30 minutes.
  1. Install a new O-ring (A) in the 1st, 2nd, and 3rd clutch pistons (B), and install a new O-ring (C) on each clutch drum (D).