A/T Clutch Clearance Inspection
  1. Release the clutch end-plate to lower the clutch end-plate, then put the clutch compressor attachment on the clutch end-plate (A).
  1. Press the clutch compressor attachment down with 147 N (15 kgf, 33 lbf) (B) using a force gauge, and read the dial indicator (C). The dial indicator reads the clearance (D) between the clutch end-plate and the top disc (E). Take measurements in at least three places, and use the average as the actual clearance.
    Clearance between Clutch End-Plate and Top Disc
    Service Limit
    R20A3 Engine Model:
    1st Clutch:
    1.28−1.48 mm (0.050−0.058 in.)
    2nd Clutch:
    0.88−1.08 mm (0.035−0.043 in.)
    3rd Clutch:
    0.93−1.13 mm (0.037−0.044 in.)
    4th Clutch:
    0.93−1.13 mm (0.037−0.044 in.)
    5th Clutch:
    0.93−1.13 mm (0.037−0.044 in.)
    K24Z3 Engine Model:
    1st Clutch:
    1.38−1.58 mm (0.054−0.062 in.)
    2nd Clutch:
    1.14−1.34 mm (0.045−0.053 in.)
    3rd Clutch:
    1.23−1.43 mm (0.048−0.056 in.)
    4th Clutch:
    0.93−1.13 mm (0.037−0.044 in.)
    5th Clutch:
    0.93−1.13 mm (0.037−0.044 in.)