A/T Paddle Shifter + (Upshift Switch) Illumination Circuit Troubleshooting
  1. Measure the voltage between cable reel 20P connector terminal No. 10 and body ground.
Is there battery voltage?
YES -
Go to Step 9 .
NO -
Check for a blown No. 6 (7.5 A) fuse in the passenger's under-dash fuse/relay box. If the fuse is OK, repair open or short in the wire between cable reel 20P connector terminal No. 10 and the passenger's under-dash fuse relay box.■
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the gauge control module connector.