A/T Clutch Pressure Control Solenoid Valve C Test
  1. Disconnect the connector (A) from A/T clutch pressure control solenoid valve C.
  1. Measure the resistance between A/T clutch pressure control solenoid valve C connector terminals No. 1 and No. 2.
    Standard:
    3−10 Ω

    • If the resistance is within the standard, go to Step 8 .
    • If the resistance is out of standard, replace A/T clutch pressure control solenoid valve C.
  1. Connect a jumper wire from the negative battery terminal to A/T clutch pressure control solenoid valve C connector terminal No. 2, and connect another jumper wire from the positive battery terminal to A/T clutch pressure control solenoid valve A connector terminal No. 1.
    • If a clicking sound is heard, the valve is OK. The test is complete, reconnect the connector, then go to Step 20 .
    • If no clicking sound is heard, go to Step 9 .