A/T Clutch Pressure Control Solenoid Valve A Test
  1. Connect the HDS to the DLC (A) located under the driver's side of the dashboard.
  1. Turn the ignition switch to ON (II). Make sure the HDS communicates with the PCM. If it does not, go to the DLC circuit troubleshooting; R20A3 engine model, K24Z3 engine model.
  1. Select Clutch Pressure Control (Linear) Solenoid Valve A in the Miscellaneous Test Menu, and test A/T clutch pressure control solenoid valve A with the HDS.
    • If the valve tests OK, the test is complete. Disconnect the HDS.
    • If the valve does not test OK, follow the instructions on the HDS.
    • If the valve does not test OK, and the HDS does not determine the cause, go to Step 4 .
  1. Remove the intake air duct.