M/T Clutch Housing Mainshaft Bearing and Oil Seal Replacement
Special Tools Required

Oil seal driver, 65 mm
 07JAD-PL90100

Adjustable bearing puller, 20−40 mm
 07JAC-PH80100

Bearing remover shaft
 07JAC-PH80200

Bearing driver attachment, 42 x 47 mm
 07746-0010300

Driver handle, 15 x 135L
 07749-0010000

Slide hammer weight
 07741-0010201
  1. Remove the ball bearing (A) from the clutch housing (B) using the 20−40 mm adjustable bearing puller (C), slide hammer weight (D) and bearing remover shaft (E).