Clutch Slave Cylinder Replacement
NOTE:
  • Use fender covers to avoid damaging painted surfaces.
  • Do not spill brake fluid on the vehicle; it may damage the paint or plastic. If brake fluid does contact the paint or plastic, wash it off immediately with water.
  • The illustration show K24Z3 engine model.
  1. Disconnect the clutch line (A) from the slave cylinder (B). To prevent spills, cover the line joint with rags or shop towels.
    NOTE: Loosen the flare nut (C) while holding the clutch line connector (D) with a wrench.
  1. Remove the slave cylinder from the transmission housing.