-
Torque the mounting bolts (A) in a crisscross pattern. Tighten the bolts in several steps to prevent warping the diaphragm spring.
|
Specified Torque:
|
25 N·m (2.6 kgf·m, 19 lbf·ft)
|
-
Remove the ring gear holder (B) and the shaft (clutch alignment tool) (C), the taper cone (clutch alignment tool) (D), and the 21 mm clutch alignment pilot.
-
Make sure the diaphragm spring fingers are all the same height.
-
Do the release bearing inspection, and replace if it necessary.
-
|
|