DTC Troubleshooting: 85-61, 85-62
  1. Measure the resistance between the No. 1 terminal of SRS unit connector B (39P) and the No. 7 terminal of the OPDS unit harness 18P connector. There should be 0−1.0 Ω.
Is the resistance as specified?
YES -
Go to Step 14 .
NO -
Open between the No. 1 terminal of the SRS unit connector B (39P) and the No. 7 terminal of the OPDS unit harness 18P connector (dashboard wire harness, right side wire harness, SRS floor wire harness, or OPDS unit harness); replace the faulty harness.■
  1. Do the battery terminal reconnection procedure.
  1. Turn the ignition switch to ON (II).