DTC Troubleshooting: 4, 5
  1. Check for continuity between LKAS camera 10P connector No. 3 terminal and LKAS control unit 26P connector No. 24 terminal.
Is there continuity?
YES -
Check for loose terminals in the LKAS camera 10P connector and LKAS control unit 26P connector. If all connections are OK, replace the LKAS camera and LKAS control unit as a set.
NO -
Repair open in the wire between the LKAS camera and LKAS control unit.■
  1. Check for DTCs with the HDS.
Is DTC 7 or 8 indicated?
YES -
Do the troubleshoot for DTC 7 or 8.■
NO -
Intermittent failure, the system is OK at this time.■