DTC Troubleshooting: 33-01, 33-06
DTC 33-01:
 Lower FET Stuck ON (Initial Diagnosis)
DTC 33-06:
 Lower FET Stuck ON (Regular Diagnosis)
  1. Turn the ignition switch to ON (II).
  1. Clear the DTC with the HDS.
  1. Turn the ignition switch to LOCK (0).
  1. Start the engine.
  1. Check for DTCs with the HDS.
Is DTC 33-01 or 33-06 indicated?
YES -
Go to Step 6 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the EPS control unit connector B (2P) and connector C (2P).
  1. Check for continuity between body ground and EPS control unit connector B (2P) terminal No. 1, connector C (2P) terminal No. 1, and connector C (2P) terminal No. 2 individually.
Is there continuity?
YES -
Go to Step 9 .
NO -
Replace the EPS control unit. ■
  1. Disconnect the EPS motor 3P connector.