Door Lock Knob Switch Test
Rear Door with Security
  1. Remove the left or right rear door panel.
  1. Disconnect the 10P connector (A) from the actuator (B).
    NOTE: The illustration shows the left rear door.
  1. Check for continuity between the terminals.
    There should be continuity between the No. 7 [No. 8] and No. 5 [No. 10] terminals when the door lock knob switch is UNLOCK position and no continuity when the switch is in the LOCK position.
    [ ]: Right rear door
  1. If the continuity is not as specified, replace the door lock actuator.