|
NOTE:
-
The HDS is required for registration of the immobilizer keys.
-
Check for aftermarket electrical equipment that can cause problems with transponder operation.
-
The immobilizer-keyless control unit can store up to six immobilizer keys.
Replace any of the keys
NOTE: If any of the registered keys were lost, do the following procedure to delete the lost registered key.
-
Have at least one original key, all other keys to be registered and the immobilizer ECM/PCM code.
-
Connect the HDS to the data link connector.
-
Turn the ignition switch to ON (II).
-
Select IMMOBILIZER from the SYSTEM SELECT MENU.
-
Select KEYS from the IMMOBILIZER MENU, then select REWRITE KEYS.
-
Select REWRITE KEYS from the KEYS.
-
Do the registration according to the instruction of HDS screen.
-
Check if the engine can be started by all the registered keys.
All keys are lost
-
Prepare all new keys and have the immobilizer ECM/PCM code.
-
Connect the HDS to the data link connector.
-
Turn the ignition switch to ON (II).
-
Select IMMOBILIZER from the SYSTEM SELECT MENU.
-
Select KEYS from the IMMOBILIZER MENU, then select REWRITE KEYS.
-
Select ALL KEYS LOST from the KEYS.
-
Do the registration according to the instruction of HDS screen.
-
Check if the engine can be started by all the registered keys.
|