Sunroof Frame and Drain Tube Replacement
  1. Install the frame and the drain tube in the reverse order of removal, and note these items:
    • Before installing the frame, clear the drain tubes and the drain valves using compressed air.
    • When installing, tie the string that was left in the pillar to the top end of the new drain tube and pull it up into the roof.
    • Check the frame seal.
    • Clean the surface of the frame.
    • When installing the frame, first attach the rear hooks into the body holes.
    • Make sure the connectors are plugged in properly.
    • When connecting the drain tube, slide it over the frame nozzle at least 10 mm (0.39 in.).
    • Install the tube clip (A) on the drain tube (B) as shown.
    • After all parts are installed, including the headliner, reset the sunroof control unit.
    • Do the glass position alignment procedure.
  1. Check for water leaks. Let the water run freely from a hose without a nozzle. Do not use a high-pressure spray.