-1.

Remove the belt hole lid (B) by releasing the hooks (C).

-2.

Gently pull back the front edge of the cover to detach the clips (D).

-3.

Pull up the cover to detach the clips (E) fastening it to the body. and the clip (F) fastening it to the rear shelf (G).

-4.

Lift the cover upward and forward to release each anchor rod (H) out through the hole in the cover.

-5.

Pull both rear seat belts (I) and rear center seat belt (J) out through the slits (K) and the hole (L) in the cover.

-6.

Carefully move the cover above the rear wheelhouse gussets (M), then remove it.