Glove Box Removal/Installation
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
  • Take care not to scratch the dashboard and its related parts.
  • When removing components, use the trim tools or equivalent.
  • LHD model is shown; RHD model is symmetrical.
  1. Open the glove box.
  1. Open the front door, and remove the passenger's dashboard side lid (A).
    -1.
    Gently pull the rear edge of the lid outward by hand to release the hooks (B).
    -2.
    Detach the clips and the hooks (C) by pulling the lid outward.
    -3.
    Release the hooks (D, E).
    -4.
    If equipped, disconnect the passenger's airbag cutoff switch connector (F).
  1. Remove the passenger's dashboard trim
  1. Close the glove box.