Dashboard Driver's Lower Cover Removal/Installation
NOTE:
  • Take care not to scratch the dashboard and its related parts.
  • When removing components, use the trim tools or equivalent.
  • LHD model is shown; RHD model is symmetrical.
  1. Loosen the tilt/telescopic lock lever, and adjust the steering column upward. Leave the lock lever still be loosened.
  1. Remove the driver's dashboard lower cover (A).
    -1.
    Open the driver's pocket (B), and remove the screw (C).
    -2.
    Pull out the bottom of the cover to detach the clips (D).
    -3.
    Pull out along the edge of the cover to detach the clips (E, F).
  1. Disconnect the connectors, if equipped:
    • The head light adjuster switch connector (G)
    • The headlight washer switch connector, the corner sensor connector, or the headlight adjuster switch/corner sensor switch connector (H)
    • The VSA/CMBS OFF switch connector (I)
    • Some RHD models: The ultrasonic sensor switch connector or the ultrasonic sensor switch/tilt sensor switch connector