Windshield Side Trim Replacement
Retainer Replacement
Gradually scrape off the adhesive tape (A) under the retainers (B) while heating it with a heat gun to about 100−120 °C (212−248 °F).
NOTE:
To prevent damage, do not heat the painted surface around the retainers too much.
To keep the exterior resin parts near the front pillar from being overheated by the heat gun, wrap them with aluminum foil.
Clean the body bonding surface with a sponge dampened in isopropyl alcohol. After cleaning, keep oil, grease, and water from getting on the surface.