Front Door Outer Handle Replacement
Remove the rod fastener (A) from the outer handle base (B), then replace it with a new one.
Install the handle in the reverse order of removal, and note these items:
Reinstall the lock cylinder (driver's door) or the outer handle holder (passenger's door) before installing the outer handle cover.
Make sure that the actuator connector is plugged in properly, and that the cylinder cable and the outer handle rod are connected securely.
Make sure the door key cylinder/door locks operate properly.
Make sure the door handle works properly.
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.