Audio/Navigation Switch Panel Removal/Installation
With Navigation System
NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the dashboard and related parts.
  • Lay a workshop towel under the parts when working on them to protect the face panel from scratches or other damage.
  • Do not work in a dusty or dirty place.
  • Discharge static electricity from your body before and during the work.
  • Do not touch the circuit board with your bare hands.
  • Do not work with dirty hands.
  • Be careful not to fold the flat plate cable.
  • Do not touch the terminal connector of the flat plate cable with your bare hands. (If you have touched it, wipe it off thoroughly.)
  1. Remove these items:
    • Driver's center trim
    • Passenger's dashboard trim
    • Passenger's center trim
    • Climate control unit
  1. Remove pull out the audio/navigation switch panel (A).
  1. Disconnect the connectors (B), and remove the audio/navigation switch panel.
  1. Remove the dashboard center vent.