OPDS Unit Replacement
Installation
  1. Place the OPDS unit (A) on the seat-back frame. Tighten the two nuts (B), and connect the connectors (C) to the OPDS unit. Reinstall the cover (D).
  1. Install the seat-back cover.
  1. Install the front seat assembly, then connect the side airbag harness 2P connector.
  1. Do the battery terminal reconnection procedure.
  1. Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.
  1. Initialize the OPDS unit.
  1. Confirm proper SRS operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.