|
Deploying Components Out of the Vehicle
If an intact airbag or tensioner has been removed from a scrapped vehicle, or has been found defective or damaged during transit, storage, or service, it should be deployed as follows:
-
Confirm that the deployment tool is functioning properly by following the check procedure Deploying Airbags in the Vehicle on the tool label.
-
Position the airbag face up, outdoors, on flat ground, at least 10 meters (30 feet) from any obstacles or people.
-
Follow
Step 1
through 12 of the in-vehicle deployment procedure.
NOTE: The driver's and front passenger's airbags have dual inflators. Twist each pair of unlike colored wires together, and clip an alligator clip to each pair.
|