Front Seat Belt Replacement
Front Seat Belt
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
  • Check the front seat belts for damage, and replace them if necessary.
  • LHD model is shown; RHD model is symmetrical.
  1. Driver's side: Prepare a sheet of cardboard which is 2−2.5 mm (0.08−0.1 in.) thick.
    NOTE: If there is no suitable cardboard, put some seats of thin paper together until they will be required thick.
  1. Driver's side: Make a jig (A) from the prepared cardboard (B).
  1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before beginning work.
  1. Slide the front seat forward fully.
Dimensions of the jig