Radiator and A/C Condenser Fan Low Speed Circuit Troubleshooting
  1. Connect the radiator fan 2P connector No. 1 terminal to body ground with a jumper wire.
  1. Turn the ignition switch to ON (II), then set the A/C button and fan control button ON.
Does the A/C condenser fan run at high speed?
YES -
Go to Step 23 .
NO -
Replace the radiator fan motor. ■
  1. Set the A/C button and fan control button to OFF, then turn the ignition switch to LOCK (0).
  1. Disconnect the jumper wire.
  1. Remove the relay circuit board from the under-hood fuse/relay box, and test the fan control relay.
Is the relay OK?
YES -
Go to Step 26 .
NO -
Replace the relay circuit board.■